Portrait Pro Forums

Full Version: white screen interface?
You're currently viewing a stripped down version of our content. View the full version with proper formatting.
Many times, I open a photo and start aligning the points, and after moving one point, when I go to move the next point, the interface turns white and I have to wait for it to turn back to visible before I can move the next point. so, what is normally a 2 minute procedure takes over 10 minutes.

Any thoughts?  Does anyone else experience this?
I would advise contacting the support team as they will be able to help you better: https://goo.gl/4tJ7yh
One possible work-around is to discard the portrait pro pre-selected outlines.

Wait until portrait pro has processed outlines for a new face then select 'new face' male/female etc. and manually put the points on the eyes, mouth etc. When done, Portrait Pro will ask if you want to discard the now overlapped selection. Do so.

It has then been my experience that now when aligning points, the program responds with much less hesitation. Your mileage may vary.